SI4022-A0-FT【PDF 16/20 页】IC TX FSK UNI 868/915MHZ 16TSSOP

Si4022

RX-TX ALIGNMENT PROCEDURES

RX-TX frequency offset can be caused only by the differences in the actual reference frequency. To minimize these errors it is

suggested to use the same crystal type and the same PCB layout for the crystal placement on the RX and TX PCBs.

To verify the possible RX-TX offset it is suggested to measure the CLK output of both chips with a high level of accuracy. Do not

measure the output at the XTL pin since the measurement process itself will change the reference frequency. Since the carrier

frequencies are derived from the reference frequency, having identical reference frequencies and nominal frequency settings at the

TX and RX side there should be no offset if the CLK signals have identical frequencies.

It is possible to monitor the actual RX-TX offset using the AFC status report included in the status byte of the receiver. By reading out

the status byte from the receiver the actual measured offset frequency will be reported. In order to get accurate values the AFC has

to be disabled during the read by clearing the "en" bit in the AFC Control Command (bit 0).

MATCHING NETWORK FOR A 50 OHM SINGLE ENDED OUTPUT

Matching Network Schematic

to RFP

to RFN

VDD

GND

50 Ohm

load

, C

[pF]

3.9

[nH]

6.8

[nH]

100

发布紧急采购，3分钟左右您将得到回复。

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购